Minicom Advanced Systems Minicom Supervisor Phantom Przewodnik Instalacji Pobierz pdf (Strona 20)

PHANTOM MX IP

29.

30.

31.

32.

Connecting the External Reset/Power Option

Refer to the of the External Power Switch Option guide to connect this to one of

the serial ports. To date supported options are:

• SPC 800/1600

• Sentry In-Line Power Module

• Intelligent Power Module

• Leunig ePowerSwitch

• Leunig ePowerSwitch –M/S

Connecting to Ethernet

The Ethernet connector on the MX IP can be used either for a 100 Mbps

100BASE-TX connection or for a 10 Mbps 10BASE-T connection. The adapter

adjusts to the appropriate operation mode automatically.

10 Mbps Connection

For 10BASE-T Ethernet networks, the Fast Ethernet adapter uses Category 3, 4,

or 5 cable. To establish a 10 Mbps connection, the cable must be connected to a

10BASE-T hub. Ensure the cable is wired appropriately for a standard 10BASE-T

adapter. Align the RJ-45 plug with the notch on the adapter's connector and insert

it into the adapter's connector.

100 Mbps Connection

For 100BASE-TX Fast Ethernet networks, the MX IP supports Category 5

cabling. To establish a 100 Mbps connection, the cable must be connected to a

100BASE-TX hub.

1. Make sure that the cable is wired appropriately for a standard 100BASE-TX

adapter.

2. Align the RJ-45 plug with the notch on the adapter's connector and insert it into

the adapter's connector.

Note! The UTP/FTP wire pairs and configuration for 100BASE-TX cable are

identical to those for 10BASE-T cable when used with Category 5 UTP/FTP

cable.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Brak uwag

Minicom Advanced Systems Minicom Supervisor Phantom Przewodnik Instalacji Strona 20