Minicom Advanced Systems DX System Podręcznik Użytkownika Pobierz pdf (Strona 20)

DX POWER SWITCH 8 PORT

Use any other straight Serial cable. For EMC reasons, we advise not to use cables

above 2.9 meters long.

DX Power Switch-Slave

RJ9F connector

Pin configuration Configuration parameters

1 (yellow) = Ground Speed 9600 bauds

2 (white) = RxD (receive commands) Parity No

3 (blue) = TxD (transmit data) Format 8 bits

4 (orange) = Ground Stop bit 1

Flow control No

A short connection cable is supplied with each DX Power Switch-Slave. Connect

the RJ9 input connector to the RJ9 output connector of a DX Power Switch-

Standalone or another DX Power Switch-S8.

If you want to connect the DX Power Switch-Slave directly to a computer Serial

port, make a Serial cable as indicated by the drawing below or contact your dealer.

Figure 4 Serial cable

11. Commanding the Power Sockets through a Web browser

1. Start the Web browser.

2. Type the IP address of your DX Power Switch-Standalone. The Password box

appears. See Figure 5.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27

Brak uwag

Minicom Advanced Systems DX System Podręcznik Użytkownika Strona 20